Original User Manual FUXTEC FX-MS152 / FX-MS162
19
9. Cold starting the engine
1. Place the device on a firm and flat surface.
Slide the engine stop switch down.
2. Set the choke lever upwards to "COLD START."
3. Press the carburetor pump about 8-10 times (until petrol flows in the line)
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, mainly fast train will provide a strong spark, and the
engine will respond after 2-3 trains.
5. Important: After the engine has responded, return the choke lever to the "WARM
START" position and immediately pull the starter again until the engine starts (see also
the video "Starting the device" on our homepage).
6. Let the engine warm-up for about 10 minutes in idle speed.
To Next Page
Loading...
Need help?
General
