Original User Manual FUXTEC FX-MSP2.2
11
4. Cold start
Please follow the instructions before operating the device:
1) move the fuel lever to the start position (Fig. 9).
2) Pull the choke lever to the ON position.
3) Slide the start/stop switch to the start position.
5) Pull the starter cable 2-3 times and release it slowly. To avoid damage to the
engine, do not remove the handle quickly.
6) Close the choke and pull the starter cable until the device ignites.
7) Let the device run at low speed for 2-3 minutes, then you can activate the
spraying system.
To Next Page
Loading...