Original User Manual FUXTEC FX-MSP2.2_rev08
12
Fig. 9
1. Choke lever
2. Petrol tap Pos. A: OPEN
Pos. B: CLOSE
3. Air Filter
4. Primary pump
5. Warm start
1) Leave the choke in the OFF position.
2) Set the fuel lever to the ON position.
3) Pull the starter cord 2-3 and release it slowly.
Attention:
1) Do not pull the starter cable beyond the dead centre. Otherwise, it may tear or
damage the device.
2)The starter cable is not part of the warranty.
To Next Page
Loading...