FUXTEC FX-MT152E - Info: Optional Accessories (Adjustable Pole Saw)

To Next Page

To Previous Page

Original Bedienungsanleitung FUXTEC FX-MT152/-MT152E/-MT252_de_en_fr_ita_rev18

2. Difficulties during operation

Situation

Cause

Solution

The engine does

not reach the

speed

Choke is in "COLD START" position, an

exhaust system is blocked no air supply,

moving elements worn, ignition spark

weak too large valve clearance, cylinder

head sooty

Open choke, replace exhaust system

Check or replace ignition coil, adjust

flywheel, spark plug

Operating

materials are

leaking

Lines to carburetor blocked Spark plug

spacing incorrect

Replace the lines and, if necessary,

the carburetor; adjust gap dimension

Engine-

Noises

Wrong choke position,

Camshaft damaged

Check/replace camshaft

Carburetor

leaking

Failure of the check valve on the tank cap

Replace the fuel filler cap

Carburetor gasket is worn out

Replace carburetor or gasket

If no troubleshooting solves the problem, contact your dealer or the

manufacturer directly. Only use original parts approved by the manufacturer.

Otherwise, there is a risk of danger.

INFO: Optional accessories (adjustable pole saw)

Assembly: Pull the knob back and position the desired angle on the attachment and

release the knob so that the pin can engage in one of the holes.

Other manuals for FUXTEC FX-MT152E