FSE F3
F3.0 Baud Rate Selection X100
Select the desired BAUD rate according to the chart. Older DDO boards have a limited
rating on the current loop ports of 1200 BAUD. If Continuous Data output is selected,
BAUD rate should be 2400 or greater.
Choices: 192, 96, 48, 24, 12, 6, 3, 1.5
F3.1 Parity Selection
d - 7 Bits, No Parity.
1 - 7 Bits, Even Parity.
2 - 7 Bits, Odd Parity.
8b - 8 Bits, No Parity.
8be - 8 Bits, Even Parity.
8bo - 8 Bits, Odd Parity.
F3.2 Checksum Transmit Enable
d - No checksum
E - Checksum transmitted, prior to CR-LF, as the 2s compliment of previously sent
characters.
F3.3 Delay After CR-LF
The amount of delay, after a carriage return or line feed is transmitted, in seconds.
Choices: 0, 0.1, 0.2, 0.5, 0.75, 1.0, 1.5
F3.4 Consecutive Number Print Enable
d - Disable the printing of the CN.
E - Enable the printing of the CN.
To Next Page
Loading...