7
2. slide the receiver clamp
out of the telephone,
turn it 180° and place it
back onto the telephone;
this clamp will hold the
receiver in case of wall-
mounting
3. hook the telephone with
the screw holes over the
screws and press it downward
4. x the telephone wire to the wall using the cable
clips
In case of wall-mounting, the table stand is NOT
used.
4.3 Batteries:
The display of the telephone is powered by the
supplied power adaptor. You can install 4 backup
batteries to ensure the display will also keep work-
ing during a power outage.
Attention: do NOT remove the battery
compartment cover while the telephone is
connected with the telephone line
To Next Page
Loading...
