Please read the following safety instructions thoroughly before using this device.
No read or no follow safety instructions will lead to severe damages or accidents.
▪ The power adapter and controller is not waterproof, please keep it dry, do not put it in water.
▪ Remove dust, dirt, oils or grease with a dry, clean cloth.
▪ Do not move forward or attach the device, if oil, grease, or damage is present!
▪ Do not disassemble the device.
▪ Reset the device when change to different sizes' tanks, it will calculate the SPT for new tank.
▪ Only suitable for TRANSPARENT glass or acrylic RIMLESS tanks.
Non-TRANSPARENT tanks will block the sensors that will lead to overpump accidents.
Chapter II: Installation Requests
▪ It is recommended to install on a rimless tank. If a rimed tank is used, the tank frame limits
the installation position of the device, or the water level cannot be monitored exactly. Then
the water level is about 2cm away from the upper edge, which may not meet the user's
expectation.
▪ Suitable for calm water surface or water surface with small fluctuation.
▪ The thickness of the tank should less than 12mm.
Chapter I : Safety Instructions
4
To Next Page
Loading...