To Next PageTo Next Page
Need help?Do you have a question about the G.T.Power C6D Pro and is the answer not in the manual?
Automatic adjustment of current based on time and voltage to prevent battery explosion.
300W output, 12A charge, 3A discharge with efficient cooling system.
Built-in balancing for lithium batteries and monitoring of individual cell voltages.
Compatible with various battery types and offers Fast Charge/Storage modes.
Delta-peak sensitivity and charging capacity limit for safe charging.
Stops charging/discharging if temperature or time limits are exceeded.
Shuts down on low voltage; cooling fan adjusts speed based on internal temperature.
Refreshes and activates NiCd/NiMH batteries with 1-5 cycles.
Covers unattended operation, environmental conditions, heat resistance, and short circuits.
Emphasizes verifying capacity/voltage and recommends series connection for lithium packs.
Discusses residual capacity, avoiding deep discharge, and memory effect in batteries.
Prefers partial discharge; avoids frequent full discharges for lithium batteries.
New NiCd packs require 10+ cycles for optimal capacity.
Reinforces that ignoring warnings can damage the unit or cause fire/injury.
Provides specific voltage and current limits for various battery types.
How to select battery mode and navigate program options like charge, discharge, storage, repair.
Balances individual cell voltages during charging for optimal pack performance.
Procedures for discharging lithium batteries to check capacity or health, avoiding deep discharge.
Adjusts battery voltage to optimal levels for long-term storage.
Repairs low-voltage cells in LiPo packs using low current for consistency.
Transmits standby discharge capacity to input battery under DC mode.
Connects battery and balance connector for charging with cell count verification.
Setting charge current and battery pack voltage for NiCd/NiMH batteries.
Setting discharge current and battery voltage for NiCd/NiMH batteries.
Balances, refreshes, or cuts off battery with 1-5 cycles and cooling process.
Recharges batteries not used long-term or those not reaching max voltage on first charge.
Transfers battery capacity for discharge via DC input, requires correct voltage and current settings.
Setting charge current and nominal voltage for Pb batteries, noting lower current limits.
Setting discharge current and nominal voltage for Pb batteries, avoiding deep discharge.
Transfers battery capacity for discharge via DC input, requires correct voltage and current settings.
Specific program for charging AGM batteries, setting current and pack voltage.
Tests DC two-phase motors by checking output current, power, and status.
Acts as a digital power supply for other instruments; not for charging.
Heats RC car tires for increased grip, requires a heating cup.
Tests pulse width value and frequency of PWM signals using a servo tester.
Tests servo parameters in different automatic or manual modes.
Sets LiPo (4.15-4.25V) and LiHv (4.30-4.4V) cutoff voltages to prevent overcharging.
Adjusts charge trigger voltage sensitivity and enables temperature-based charging stop.
Sets cooling time between cycles and enables/disables trickle charging mode.
Sets a safety timer to prevent overcharging and a capacity limit to stop charging/discharging.
Controls audio alerts and sets the minimum input voltage for operation.
Option to load factory settings and view the product version information.
Lists technical standards and certifications the product meets (CE, FCC).
General| Brand | G.T.Power |
|---|---|
| Model | C6D Pro |
| Category | Battery Charger |
| Language | English |
