Inertia Electric Radiators
4
3.- USING THE THERMAL RADIATOR
ELECTRONICS MODELS RFP
Operation in electronic models is controlled by means of two rotary knobs.
It is possible to regulate the temperature level with accuracy by means of
the temperature selector. The heating indicator will be lit when the
heater is consuming energy. When this dial is set in * position the heater is
in frost protection mode, at this stage if the room temperature drops below
3ºC the heater will connect itself automatically.
There are three selectable positions with the mode selector dial:
0 : The heater is switched off permanently. No frost protection mode
here.
: SUN mode on, the heater maintains the set temperature with the
temperature selector dial.
: Moon mode on, the heater maintains a temperature 3ºC lower than
the one set with the temperature selector dial.
To Next Page
Loading...
