14
en Getting to know your appliance
Changing the filter cartridge with bypass or replacing it
with a water filter
The filter cartridge with bypass can be kept in the
appliance permanently; it does not need to be changed.
However, you can replace the filter cartridge with
bypass if necessary or replace it with a water filter.
Note:
After installing a water filter or filter cartridge with
bypass, allow water to dispense for 5 minutes for
hygiene reasons and then discard. Discard the ice
cubes produced within the first 24 hours for hygiene
reasons.
1 Turn the cap of the filter cartridge with bypass anti-
clockwise.
2 Pull out the filter cartridge with bypass.
3 Remove the protective cap of the new water filter or
the new filter cartridge with bypass.
4 Remove the cap of the old filter cartridge with
bypass and put it on the new water filter or filter
cartridge with bypass.
5 Slide the new water filter or filter cartridge with
bypass into the filter opening as far as it will go.
Note:
The cap must be kept vertical when doing this.
6 Turn the water filter or filter cartridge with bypass
clockwise to the marking.
Note:
If you do not turn the water filter or the filter
cartridge with bypass far enough, water will leak
out, causing damage.
7 When installing a water filter: switch the water filter
counter on.
~
"Reset water filter counter" on page 16
Note:
The water filter counter is not required when using
a filter cartridge with bypass and therefore remains
switched off.
8 Allow water to dispense for 5 minutes and discard.
9 Drain the water from the filter cartridge with bypass
which has been removed.
Note:
You can dispose of the filter cartridge with bypass
which has been removed in your household waste.
To Next Page
Loading...
