• 37 •
24 Turn the selector switch to the
“ ”
central position.
25 At the end, rell the water tank.
Reassemble the external part of the Pan-
narello.
The descaling cycle is complete.
Start the machine as described in the
manual and perform normal warm-up
and rinse operations: the machine is now
ready for product brewing.
If the machine is switched o
during the descaling cycle,
next time the machine is switched
on the cycle must be repeated from
the point it has been paused.
The descaling solution is to
be disposed of according
to the manufacturer’s instructions
and/or the regulations in force in the
country of use.
After completing the des-
caling cycle, wash the brew
group as described in the “Brew
Group” section in the “Cleaning and
Maintenance” chapter.
Remarks on descaling
The machine you have purchased is
equipped with advanced software to
check the quantity of used water in order
to provide reliable information about the
right time to carry out descaling opera-
tions.
This software has been programmed for
standard water hardness.
In these specific cases, it is recommended
to perform descaling cycles every 1-2
months, even if the machine does not
signal it.
4219-465-04381 GAG. MAN. BRERA IT-EN-DE-FR Rev.00.indd 37 14/10/2020 14:49:24
To Next Page
Loading...
