Gako Unguator e/s - Quality Verification

18
UNGUATOR
®
Mixing System
System, even thick pastes can be
dispensed via the small dispensing
opening in the screw cap or trans-
ferred to small UNGUATOR
®
Jars
using the UNGUATOR
®
Coupling.
The material outlet velocity depends
on viscosity which may be reduced
through heating.
The air pressure that had developed
in the lower chamber of the UNGU-
ATOR
®
Jar can be relieved by open-
ing the valve screw. This is manda-
tory after the transfer process using
the UNGUATOR
®
Coupling before
the smaller UNGUATOR
®
Jar is
removed. Otherwise this may result
in considerable contamination of the
immediate environment, depending
on formulation viscosity.
1.4 Quality Verification
The production site for all UNGUATOR
®
products is certified in accordance with DIN
EN ISO 9001. Periodic quality controls not only guarantee the outstanding but also
most notably the lasting quality of the UNGUATOR
®
Mixing System.
• UNGUATOR
®
Applicators, couplings and jars are made of polypropylene (PP)
and the UNGUATOR
®
Varionozzles of polyethylene (PE),
• The head of the UNGUATOR
®
SMB is made of polyoxymethylene (POM) and
the mixing blades of the UNGUATOR
®
Disp. Blade of polyamide (PA).
• The shaft of the UNGUATOR
®
MB is made of stainless steel (quality: 1.4301)
and hardened through titan nitration (gold-colored).
• The materials and pigments deployed are physiologically safe.
• All priceable UNGUATOR
®
line products (UNGUATOR
®
Jar, Disp. Blade,
Applicator and Varionozzle) can be found under UNGUATOR
®
... since the
designations start with UNGUATOR
®
in the EPDS and the German “Hilfstaxe”
(a database of approx. 340.000 medicines and other pharmaceutical products).
Fig. 1-16: AirDynamic
®
System