LOCATION REQUIREMENTS
LOCATION REQUIREMENTS
1. It is recommended not to install the wine cooler near an oven,
radiator, or other heat source.
2. Do not install in a location where the temperature will fall below
55 °F (13 °C). For best performance, do not install the wine
cooler behind a cabinet door.
4. Leave a minimum of 1/2" (1.27 cm) between each side of
the appliance and the wall. The top and back of the
appliance should have a minimun 1 ½" (3.81 cm) clearance.
This allows for proper air circulation. This appliance is
intended to be free-standing and should not be built-in or
placed in arecessed area.
3. The wine cooler should be located on a firm, flat surface that
is strong enough to support the wine cooler when it is fully
loaded.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from wine cooler.
Failure to do so can result in death, explosion, or fire.
WARNING
LOCATION REQUIREMENTS
6. Do not put the unit in a place where it is subjected to sunlight.
7. Do not put the unit in a palce where the ambient temperature
is more than 90 °F (32 °C).
5. The wine cooler legs must be adjusted during installation
in order to function properly. The leveling legs on the front
corners can be adjusted by turning clockwise to raise the
appliance, and counter-clockwise to lower it. Be sure to
have the appliance sloped slightly backward to ensure that
the door closes tightly.
4
Excessive Weight Hazard
Use two or more people to move and install wine cooler.
Failure to do so can result in back or other injury.
WARNING
INSTALLATION INSTRUCTIONS
4
To Next Page
Loading...
Need help?
General
