EasyManua.ls Logo

Galanz P100D48AL-JC - Basic Controls; Function Description; Setting the Clock; Setting Microwave Cooking Program

Galanz P100D48AL-JC
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Learn about your microwave oven.
CAUTION
To avoid risk of personal injury or property damage, do not operation the microwave oven
empty.
To avoid risk of personal injury or property damage, do not use stoneware, aluminum foil,
Setting the Clock
This is a 12 or 24 hour clock. In standby mode, touch Clock pad once to choose 12 hour clock and if
you want to choose 24 hour clock, press the pad again
Example: Suppose you want to set the clock for 8:08 am.
1. In standby mode, touch
Clock pad once or twice.
2. Press number pads
8, 0, 8, the display will show08:08”.
3. Touch
Start/Add 30Sec to confirm
Setting Microwave cooking program
For microwave cooking, cooking power and time should be set. The longest cooking time you can set is
99 minutes, 99 seconds. Press
Power Level pad once and then press number pads to choose cooking
power level.
BASIC CONTROLS
Function description:
When the oven first plugged in, the display will show “12:00” and “:” flashing.
When cooking setting is interrupted for 1 minute, the system will back to the standby mode
automatically.
During cooking, if press Stop/Cancel pad once or open the door, the program will be paused,
close the door, then press Start/Add 30Sec pad to resume, but if press Stop/Cancel pad
twice, the program will be canceled.
After ending cooking, “END” will display and the system will sound beeps to remind user every
two minutes until user press Stop/Cancel pad or open the door.
SIGNALS DURING OVEN SETTINGS
ONE SIGNAL: Oven accepts the entry.
TWO SIGNALS: Oven does not accept the entry, please check and try again.
NOTE:
During cooking, you can press Clock pad to check the clock.
00:00” will display and two beeps will sound to remind user to resume load the time, if
you enter time is beyond the scope of clock when you set the clock.

Other manuals for Galanz P100D48AL-JC

Related product manuals