GalaxySpas Rosa - Heat Pump Details

9
Heat Pump
• A heat pump can be added to the purchase of any Elite and Luxury Series spa.
• If you have added this oponal extra, it must be placed a minimum of 1.2m away from the
spa so it can not be used as a climbable surface for a child to get into the spa.
• There also needs to be a minimum 3m clearance in front and 1.5m clearance behind the
heat pump for it to eciently circulate air ow.
• The heat pump also needs to be on a concrete foundaon. See the diagram on page 14,
Foundaon Requirements.
Cover Lier
• A cover lier is an accessory that aaches to the spa pool and supports removing the cover.
• The benets of a cover lier are twofold: it takes the weight of the cover, making it much easier
for one person to li the cover on and o the spa and it also protects the cover from damage.
• Cover liers require rear and somemes side clearance. See below for details:
Spa
Cover Lier
Standard Cover Lier
This will need 500mm back clearance and 100mm side clearance for it to operate
(50mm each side). These cover liers t the following models:
Rosa, Juno, Ceres, Venus, Aquila, Jupiter, Capella, Draco I and Draco II.