Page
Restrain the animal in the crush using the backing bar.
Some animals pull back their head against the head
bail (head gate). If the crush (chute) is fitted with a
backing bar feature, then use this to push the animal
forward to expose its neck.
Disconnect the top strap on the fitment side.
Disconnect the top strap on the same side where you
intend to reattach the clip.
Fit the neckband on the animal.
Place the neckband around the head of the animal
ensuring the LED indicator and cows head imprint
are facing forward, and the audio speaker holes face
backwards, towards the animal’s brisket.
Adjust the chains to obtain the correct fit.
The chain length can be adjusted by lifting it up
through the slot in the buckle, adjusting the length
and then re-engaging the chain in the slot by pulling
down firmly. Ensure that both sides of the chain are
the same length.
Clip the buckle together to secure the neckband.
Important: Use a Hand Held Reader (HHR) to
scan the RFID chip located in the base of the
neckband before fitment. Refer to Assigning
Neckbands to animals p.
Check the space between the neckband and the
animal’s neck ridge.
Ensure the neckband’s tightness by lifting the top strap
above the neck ridge. There should be room to fit your
fist between the neck and the strap comfortably.
To Next Page
Loading...
