Need help?Do you have a question about the Galletti LCX164HL and is the answer not in the manual?
Ensure adequate air volume for condenser coils to prevent re-aspiration and performance loss.
Connect pipes using flexible couplings, install necessary components like filters and valves.
Follow specific steps to fill the tank and pressurize the system to prevent cavitation or explosion.
Ensure mains supply compatibility, proper cable sizing, and correct phase sequence.
Verify valve positions, electrical connections, voltage, phase sequence, and refrigerant leaks.
Turn on main switch, select mode, and press ON. Check water flow, compressor start, and temperature differential.
Verify phase sequence relay, water temperature, and refrigerant levels. Check overheating and subcooling.
Monitor liquid level indicator, condensation/evaporation temperatures, overheating, and subcooling.
Manually reset type that stops compressor when discharge pressure exceeds set value.
Perform operations by qualified personnel only. Disconnect power before work. Be careful of hot surfaces and sharp fins.
Carry out periodic checks on safety devices, terminals, refrigerant levels, oil levels, water leaks, and filters.
Charge in liquid phase. Ensure correct percentage of components. Use only R410A.
To Next Page
General
