Need help?Do you have a question about the Gallien-Krueger 700RB series and is the answer not in the manual?
Congratulates the user on their purchase and expresses satisfaction with the product.
Connect power, set power switch to Off, and connect to AC outlet.
Connect speaker cabinets to specified outputs, minding load limits.
Set EQ/Boost to 12 o'clock, Voicing Filters down, Volume/Master at 0.
Connect bass, power on, use -10dB pad if clip LED flashes.
Set Volume to 12 o'clock, slowly increase Master Volume.
Check sound level, prioritize Woofer-Master for more volume.
Fine-tune sound with small, incremental adjustments using active circuits.
Scoops mids, boosts highs and lows for a unique GK sound.
Adapts low-end response for 4 or 5-string basses.
Adds 'growl' with Boost; Master controls overall volume.
Provides balanced direct output for PA/recording, with Pre/Post EQ options.
Connects RBH cabinets with 4-conductor Speakon for separate woofer/tweeter signals.
Uses 2-conductor Speakon or 1/4" cables for full-range output, bypassing the 50W amp.
Ensures proper voltage and amperage for safe operation and to prevent damage.
Recommends dedicated circuits to avoid tripping breakers or noise.
Advises using only the supplied cord and avoiding damage to cords.
Pull the plug, not the cord; disconnect if unused for extended periods.
Warns against opening unit due to shock hazard and voiding warranty.
Suggests saving packing materials for future shipping needs.
Place on a level surface, ensure ventilation clearance, avoid extreme environments.
Disconnect all cords before moving the unit to prevent damage.
Use a soft, dry cloth; mild soapy water if needed; avoid harsh chemicals.
Unit is rugged; only maintenance needed is cleaning; use a road case for frequent moves.
Controls for signal input, output level, muting, and tuning connection.
Features for adjusting bass tone, including EQ bands and voicing filters.
Controls for amplifier gain, speaker output levels, and crossover settings.
Jacks for external effects and the main power switch.
Connection points for power and speakers, including Bi-Amp setup.
Details 380W output, impedance limits, and recommended speaker loads.
Important warnings regarding Speakon cable use and amplifier connection.
Describes speaker configurations for 700RB/112, 700RB/115, and 700RB/210.
Specifies maximum speaker load when the internal speaker is connected.
Specifies maximum speaker load when the internal speaker is disconnected.
Instructions for engaging and disengaging the transport system.
Guidance on using the combo for practicing or projection.
Highlights key features like high current supply, Bi-Amp, and cooling.
Discusses high current capacity and response to transients.
Explains how Bi-Amp achieves clarity and growl.
Describes the electronic crossover's quality and sound reproduction.
Explains the unique GK EQ's effectiveness for bass.
Details Contour and String Bass filters for tone shaping.
Explains Gate Induced Valve Effect technology for harmonic content.
Describes the dual rail power supply and fan system for cooler operation.
Details protection against shorts, miswiring, and unsafe conditions.
Discusses high gain, high headroom, low noise input stage.
Details the use of 4-conductor Speakon cables for Bi-Amp connection.
Visual representation of the amplifier's internal signal flow.
Details output power, input, equalizer, filters, crossover, and noise.
Information on cooling system and amplifier protection features.
Physical dimensions and weight of the amplifier.
Lists voltage and frequency requirements for different regions.
General| Input Impedance | 1M ohms |
|---|---|
| Voicing Filters | Contour |
| Outputs | 1/4" speaker outputs |
| Effects Loop | Yes |
| Controls | Gain, Bass, Treble, Master |
To Next Page