Gallo Tech GTStarter-2 GTS-2 User Manual

© Copyright
Gallo Technologies
. All Right Reserved
-
1
-
Rev.
V8.
2
-
202
12
Operation & Installation Manual
(V8.2)
Keyless
Model # GTS
–
2
Keyless RFID
Push Button Start &
Security
System
DISCLAIMER:
This installation manual is designed for the
professional
installer with a
good understanding
of automotive electrical
s
ystems,
and if the vehicle is so equipped,
the ability to
disable the steering column locking mechanism.
To ease
in
proper
installation, we
recommend
that
the installer
READ THIS MANUAL
thoroughly
before beginning
the
installation. This manual is provided
as a GENERAL GUIDELINE and the information contained herein may differ
from your vehicle. Gallo Technologies and its’ vendors shall not be liable for any accident resulting from the
mis
use
of this product. This
product
is designed to be professionally inst
alled into a vehicle in which all systems and
associated components are in perfect working condition.
DAMAGE to the
GTStarter
-
2
unit
resulting from incorrect
installation or failure to follow guidelines stated in this manual
,
will not be covered under warr
anty and will be subject
to repair or replacement charges
.
Links to nation
-
wide Alarm installers can be found on our web site at
www.GalloTech.com
.
Table of Contents
1.1 Introduction
(page 2)
1.2 Remote Key FOB O
peration
(page 3)
1.3 “
PUSH START STOP” BUTTON OPERATION
(page 5)
1.
4
GTStarter
-
2
Function Options
(page 6)
1.
5
Key FOB & Programming Function Set Up
(page 8)
1.
6
Installation Instructions
(page 9)
1.
7
Final Installation
(page 14)
1.
8
Troubleshooting
(pag
e 15)
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference
receiv
ed, including
interference that may cause undesired operation.
www
.GalloTech.com

Gallo Tech GTStarter-2 GTS-2 Specifications

General

Brand	Gallo Tech
Model	GTStarter-2 GTS-2
Category	Remote Starter
Language	English

Summary

RFID Key FOB Operation

Key FOB Lock Button Functions

Key FOB Unlock Button Functions

Push Start Stop Button Operation

Engine Start and Stop Procedure

Detailed procedure for starting and stopping the vehicle's engine.

Installation Instructions

Connector C1: Power and Ignition Wiring

Installation of the 4-pin harness for power and ignition connections.

Connector C2: LF Antenna Installation

Connector C3: Door Lock/Unlock Wiring

Instructions for connecting the 6-pin harness for door lock/unlock circuits.

Connector C4-C7 Wiring Harnesses

Connector C8-C10 Wiring Harnesses

Final Installation Checks and Testing

Verifying all electrical connections and testing starting functions.

Troubleshooting

Engine Cranks But Will Not Start

Diagnosing and resolving issues where the engine cranks but won't start.

Engine Starts in Drive or Reverse Gear

Troubleshooting the transmission interlock preventing starting in gear.

Engine Starts Without Clutch Pedal

Resolving issues with manual transmission starting without clutch engagement.

Accessory Power Issues During Cranking

Addressing problems with accessories not turning off or back on during cranking.

Incorrect Door Lock/Unlock Operation