GAME SandPRO 50D - User Manual

Questions and Answers

M
Mrs. Shelby JonesAug 5, 2025
What to do if my GAME SandPRO 50D Water Filtration Systems pump does not run?
- C
  Charles Allen MDAug 5, 2025
  If the pump of your GAME Water Filtration System doesn't run, there are several potential causes: * **Not plugged in:** Check the socket and power cord to ensure they are properly connected. * **GFCI/or main circuit breaker tripped:** Switch on the breaker. If it trips again immediately, it indicates a defect in the pump or controls. * **Faulty Pump Motor:** The pump/motor assembly may need replacement.
S
Suzanne KnightAug 9, 2025
Why is there sand in my pool with GAME SandPRO 50D?
- D
  David VazquezAug 9, 2025
  If you notice sand in your pool when using GAME Water Filtration Systems, here are a few possible reasons: * **Newly replaced sand:** Undersized grains may still be present. Backwash several times until the backwash water is clear. * **Sand in central valve (from backwash):** Purge into the drainpipe for 30 seconds. * **Damaged filter bottom strainer:** The filter's bottom strainer may be damaged and needs replacement.
K
Kelly DiazAug 13, 2025
How to fix a leaking filter in GAME Water Filtration Systems?
- M
  mooretinaAug 13, 2025
  If your GAME Water Filtration System filter is leaking: * Check the seal and replace it if it's faulty. * Tighten the clamp, but be careful not to overtighten the hose clamps (35 in/lb max torque).
R
Robin WilsonAug 18, 2025
Why is there air in my GAME SandPRO 50D Water Filtration Systems?
- J
  jasminehowellAug 18, 2025
  If you find air in your GAME Water Filtration System, it could be due to a low water level or because the system was recently opened for service. While the pump is running, loosen (but do not remove) the pressure gauge or pressure gauge plug to release the air. Then, retighten the gauge or plug.
L
Lisa SmithAug 22, 2025
What to do if water flows into the drainpipe from GAME SandPRO 50D?
- C
  Corey WhiteAug 22, 2025
  If water flows into the drainpipe from your GAME Water Filtration System, it may be caused by dirt around the seal of the 4-way valve. Remove the 4-way valve from the tank and clean the seal.
S
Steven BishopAug 27, 2025
How to remove air in the pump of GAME SandPRO 50D Water Filtration Systems?
- H
  hwilsonAug 27, 2025
  If there's air in the pump of your GAME Water Filtration System, it might be due to a poor seal on the intake side. Tighten the hose clamps and connection fittings to resolve this.
W
william94Aug 30, 2025
How to fix low pressure in GAME SandPRO 50D?
- K
  Kristin TaylorAug 30, 2025
  If the pressure is too low in your GAME Water Filtration System, the hair and lint strainer basket may be dirty. Clean the hair and lint strainer.