EasyManua.ls Logo

Gami T240 - INSTALLATION; Reception; Connection to Electricity Supply

Gami T240
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 10 -
Via Lago di Lavarone, 14 Tel. +390445576205
36015 Schio (Vi), Italy Fax +390445500026
Cap.soc. Euro 90.000,00 www.gamitaly.com
C.F./P.I. 00932420243 gami@gamitaly.com
R.I. di Vicenza 00932420243 e al R.E.A. al N. 283138
INSTALLATION
Reception
Remove the packing and check that there is no damage.
Notify the carrier of any damage immediately.
Connection to electricity supply
Connection to electricity supply must be made by qualified staff.
Make sure the electricity line voltage is the same as the one indicated on the
machine’s connection plate.
The phase sequence relay inside the electric panel prevents the possibility of
the direction in which the motors rotate from being inverted; therefore, if the
message ALL FAS appears on the control panel screen when the door-locking
general disconnecting switch (on the rear casing) is switched on, just remove
the plug and invert two phases making sure never to move the earthing cable
(yellow green) and neutral cable (blue); then repeat connection to power
supply.
Electricity must be supplied through a quadruple
socket + earth.
Connection must be made in compliance with
standards in force in the Country in which the
machine is being installed.