Via Lago di Lavarone, 14 Tel. +390445576205
36015 Schio (Vi), Italy Fax +390445500026
Cap.soc. Euro 90.000,00 www.gamitaly.com
C.F./P.I. 00932420243 gami@gamitaly.com
R.I. di Vicenza 00932420243 e al R.E.A. al N. 283138
1.1.3 Thermostat 3 (Auger resistor)
This thermostat regulates the auger heating temperature and it works provided
that the tank heating is switched on and tempering is switched off.
Press the SET K103 button to view and alter the regulation set-point value.
Press the two K101/K102 arrows for tempering increasing/decreasing to view the
actual temperature of the auger.
1.1.4 Mixer
This command comes directly from its own special push-button. Function state is
indicated by the LED located on the push-button itself.
The mixer will only switch on when the chocolate in the tank has reached the
SET temperature, otherwise it will not switch on even if it is enabled and the LED
flashes indicating waiting time before the mixer switches on.
1.1.5 Auger
This command comes directly from its own special push-button. Function state is
indicated by the LED located on the push-button itself.
The auger will only switch on when the chocolate in the tank has reached the
SET temperature, otherwise it will not switch on even if it is enabled and the LED
flashes indicating waiting time before the auger switches on.
The auger will only switch off when the chocolate has reached a temperature of
40° C that is the set-point value. While reaching this value the auger remains
switched on even if disabled and the LED will flash indicating to wait for some
time.
The auger may be stopped temporarily (using the pedal) for a time set by the
Manufacturer in the machine’s parameters. This stop function is simply activated
(just one stop) if the doser is switched off. If not, see doser operation described
here below (1.1.8).
1.1.6 Vibrating table vibrator
This command comes directly from its own special push-button. Function state is
indicated by the LED located on the push-button itself.
1.1.7 Vibrating table vibrator resistor
This command comes directly from its own special push-button. Function state is
indicated by the LED located on the push-button itself.
To Next Page
Loading...