31
Tip! Select the opening direction before installing the segment.
Chapter 2 Installation
Altering the opening direction
1 Open the door and remove the cover cap at the top of the frame. Do so by placing a screw driver’s flat head
into the holes underneath and gently twist.
2 Close the door and remove the upper hinge by loosening the 2 screws.
3 Remove the door by lifting it carefully away from the lower hinge.
4 Remove the lower hinge by loosening the 2 screws.
5 Fit the hinge from step 2 at the other lower side (diagonally opposite).
6 Remove the hand grip and trim strip by partially removing the magnetic frame and the screws and
attachment strip this conceals.
7 Fit the trim strip, attachment strip and hand grip to the hinge position on the other side, using the 4
screws.
8 Press the magnetic frame back into its original position.
9 Replace the door and fit the upper hinge cover cap using the 2 screws (i.e. the hinge which you removed in
step 4).
10 Place the cover back on. Slide the cover backwards (never downwards).
screw
attachment
strip
trim strip
magnetic gasket
screw
hinge
cover
To Next Page
Loading...
