40
Fault finding
Please note!
Always remove the plug from the socket when carrying out repairs!
The cabinet does not start.
• Check the plug.
• Restore the power supply by replacing a faulty fuse or by using the on/off switch.
• Contact your local service organisation.
Temperature is too high, in spite of recent adjustment of thermostat.
• Check/repair power supply.
• Remove contents which may obstruct ventilation.
• Clean magnetic strip, replace if necessary.
• Defrost evaporator.
Temperature is too low, in spite of recent adjustment of thermostat.
• Thermostat is faulty. Contact your local service organisation.
Water leak
• Defrost regularly – if necessary extra manual defrost cycle.
• Clean/unblock water drip tray.
• Clean the defrost water evaporator tray.
• Contact your local service organisation.
Plug lead
• To prevent accidents the plug lead, if damaged, may only be replaced by the
service/maintenance organisation or qualified installer.
To Next Page
Loading...
