Each time a full bobbin is inserted in
the machine, the bobbin count
screen should be accessed and +
(plus) should be pressed to reset it
back to the full count. Failure to reset
bobbin count when full bobbin is
installed will result in false alarms.
Bobbin count screen can be
accessed at any time to check the
number of counts remaining even
though alerts have not been
activated. Run/Stop and Needle
Position switches will not operate
while bobbin count screen is open.
Touch – (minus) to exit screen and
return to normal operation.
Motor Run-Time Clock
To read the built-in Run-Time Clock,
press M on the display panel while
turning on the power. Hold M for
approximately two seconds to allow
for run time clock to boot up. The
hours and minutes shown represent
the total time the motor on this
machine has run.
9
To Previous Page
Loading...
