4. Depending on specifications you will receive a device
pre-set for your car or without any settings. You can
determine if the device has any settings from the mobile
app or LED indicators (for GÄN GA+ only).
– LEDs ARE SOLID BLUE, YELLOW, RED – device is not
pre-set. You can set up the device via your PC or
Smartphone (for GÄN GA+ only), see the SETTINGS
Section.
– LED IS FLASHING RED – device is pre-set, calibration is
in progress. When plugged in for the first time, the
calibration takes 3 minutes. After the calibration is finished
the device is in the working mode (LED is solid green). A
120 km drive is required before the device adapts to the
engine control unit.
08
To Next Page
Loading...