SETUP VIA PC
You need Internet connection in order to set up your
device via PC. Download GÄN PC from our website
www.gantuning.com in INSTALLATION section. Connect
the device to your PC with a Micro USB cable and run
the GÄN PC.
If your device has no vehicle specific data installed or you
would like to program it for another vehicle, choose your
vehicle in the program and click “Apply”, then necessary
settings will be sent to the device. The device has a limit
of 5 tune files for different vehicles. Retuning to the
previously selected vehicle doesn’t count.
The calibration begins after the device is installed in the
vehicle. It takes 3 minutes. A 120 km drive is required
before the device adapts to the engine control unit.
09
To Next Page
Loading...