G&G WatchBot - Page 20

20
WatchBot Home Security Camera - User Guide
Above: Example showing WEP Sengs
When all elds are completed, click Submit to save the sengs. The camera will reboot.
Unplugthenetworkcable
Once the sengs above have been saved and the camera has rebooted, unplug the network
cable from the camera, then unplug the power cable.
Re-aach the power cable and wait approximately 30 seconds to 1 minute for the device to
appear on the wireless LAN. (You can test this by aempng to access your camera interface
via Internet Explorer).
Your WatchBot camera is now funconing wirelessly and will only need it’s power cable
aached in order to operate.