GANSHORN Medizin Electronic GmbH Service Manual Ref.No. 03 140 0 046
PowerCube-Ergo-CASE_ENG_rev.02, 23.11.2012 Chapter 5, software, page 3 of 4
Updates for LF8
Please use the GANSHORN Installation Assistant for every update.
We strongly recommend to perform a security backup of the actual LF8-installation folder before starting
the update.
INFORMATION
Please keep care, that some files are overwritten that may be customized: *.frm, texte.*, messwert.*,
messwert2.*). For further information about the LF8-files see
=> Instruction manual Software LF8,
Chapter 4, Data Management!
After having performed the installation and before performing measurements with the devices, please
ensure
Check or entry of the ambient parameters
Volume calibration of the pneumotach “Blendenspirozeptor”
=> Instruction manual Software LF8,
Appendix A, Calibrations and Tests
Gas calibration of the PowerCube-Ergo
=> Instruction Manual PowerCube-Ergo,
Chapter 5, Calibrations and Tests, Ergo calibration (O2/CO2)
If necessary: Allocate external devices or check the parameter allocation
If necessary: Perform customized settings (customer data for report header, input of system
specific data into the LF8-system, etc.)
We strongly recommend to perform a system-printout and a security backup of the complete
LF8-installation folder after the update
Warm-up-time
De-installation of LF8
For de-installation erase the installation directory of LF8 (e.g. C:\lf8) completely with all sub-directories.
This removes LF8 completely from the PC. No registries are made into other files, into the Windows
®
registry or in any ini-files during installation.
De-installation of the BDE / the PDF Creator
To remove the BDE and the PDF-Creator (automatically installed in version LF8.5G and higher) use the
Windows
®
“Control Panel/Software” or “Control Panel/Add or Remove” programs
To Next Page
Loading...