QCXSUN was developped for all GAPOSA radio motors installed in interior/exterior blinds or roller shutters.
NOTE: Before starting the programming procedure it is necessary to check which interior blind, exterior blinds or
roller shutters will be controlled by the sun sensor.
1. HOW DOES IT WORK
SENSOR OFF. The sensor is completely inactive. It does not measure light intensity nor transmits radio signals.
SENSOR ON. The sensor measures light intensity every 90 seconds (1 ash of the LED).
NOTE: When the battery is inserted for the rst time , the default factory setting of the sun sensor is OFF with a
threshhold of 1 (low light)
2. FUNCTIONS
When the sensor detects an increase in brightness
(above the threshold) it closes the blind/shutter
and stops measuring light intensity for 20 minutes
before starting again every 90 sec.
When the sensor detects a decrease in brightness
(below the threshold) it opens the blind/shutter and
stops measuring light intensity for 1 minute before
starting again every 90 sec
led
front rear
suction
cup
1
2
3
OFF - Disables the sun sensor (1 slow ash)
ON - Activates the sun sensor (3 quick ashes)
SEL - Sun sensibility threshold adjustment
To Next Page
Loading...