Gardasoft Vision PP420 - Webpage Configuration; Index Page; General Configuration Page

11 Webpage Configuration
The PP420 has a small webserver inside, so that it can be configured from a standard web
browser, such as Internet Explorer.
The IP address of the PP420 must be known (see the section on “Ethernet Setup.” Open a web
browser window and type the IP address (for example 192.168.1.71) of the PP420 into the URL
box at the top. The main page of the PP420 webserver should be shown.
The configuration pages can be protected using a password.
11.1 Index Page
The index page shows general information about the PP420. Links are provided to the configuration pages.
11.2 General Configuration Page
The General Configuration page allows the webpage protection password to be set or cleared and
the internal trigger to be set up. Also any Ethernet command from Section 12 can be entered.
11.3 Channel Configuration Pages
There is one Channel Configuration Page for each output channel. All the parameters for each
output channel can be set up. Press the Submit button to update the PP420 and save the changes
to non-volatile memory.