Gardasoft Vision PP420 - Switched Mode; Pulse Mode

A. Timing
The following timings apply for firmware revision V011.
A.1 Switched Mode
The maximum delay from a trigger input changing to the output current being turned on or off is
10us.
A.2 Pulse Mode
For short delays and pulse widths the actual timings are repeatable but not exact. Timings are
dependent on the output current as described in the two tables below.
The timings given are for channel 1 and assume a trigger input signal of 5V. All times are in
microseconds.
Programmed Actual timing
Output current = 100mA
Actual timing
Output current = 1 A
Delay Pulse
Width
Delay Pulse
Width
Delay Pulse
Width
20us 20us
40us 40us
100us 100us