4. Operation
Filling the pump:
8
7
1
6
5
min. 1 m
5
1
DANGER! Electric shock!
Risk of injury due to electric shock.
v Disconnect from the mains before filling the
Garden Pump.
ATTENTION! Dry-Running
v Before each operation, fill the pump to overflowing
with approx. 2 to 3 l of the liquid to be pumped!
1. Unscrew the screw fitting
6
of the filler cap
7
by hand.
2. Fill the pump via the filler cap
7
to overflowing with
approx. 2 to 3 l of the liquid to be pumped.
3. Tighten the screw fitting
6
of the filler cap
7
by hand
(do not use pliers).
4. Open any shut-off valves in the delivery line (accessories,
water stop, etc.).
5. Drain remaining water
5
in pressure hose so that air can
escape during the suction process.
6. Insert the power plug.
7. Lift and hold the delivery hose
5
at least 1 m vertically above
the pump, press the On/Off switch
8
(On/Off switch shines)
and wait until the pump has primed.
v If the pump does not deliver after approx. 5 minutes,
switch off the pump (press On/Off switch
8
)
(see 7. Trouble-Shooting).
The specified maximum self-priming suction height of 7 m is
reached only if the pump is filled via the filler neck
7
up to the
overflow and if, while doing so and during the self-priming, the
delivery hose
5
is held up sufficiently high to prevent any flow
medium escaping from the pump via the delivery hose
5
.
5. Putting into Storage
Overwintering / Storage:
9
Before the start of the frost period the Garden Pump should be
stored protected from frost.
1. Open the water drain screw
9
.
The Garden Pump drains.
2. Store your Garden Pump so that it is protected from frost.
Disposal:
(in accordance with
RL 2012/19/EU)
The product must not be added to normal household waste.
It must be disposed of in line with local environmental regulations.
14
GB
To Next Page
Loading...
