4. How the Water Timer Electronic Works
This GARDENA Water Timer Electronic C 14 e allows you to set different
watering cycles for different watering times independent of whether you
are using a sprinkler, a sprinkler system installation or a drip-head
watering system to water your garden.
Your Water Timer Electronic will water your garden completely automati cal-
ly according to the program you choose. You can set the timer to water your
garden early in the morning or late at night when water evaporates
the least, or while you are on holiday.
5. Operating Parts
1
Control unit Accompanying accessories
2
Display
8
G ¾ adaptor for sleeve nut
3
Battery compartment
9
GARDENA threaded tap
4
Connection plug for control unit connector
5
Release button for control unit
6
Connection for Soil Moisture
Sensor / Rain Sensor Option
7
Sleeve nut
0
Anti-theft protection
6. Preparation for Use
Before you use your Water Timer Electronic you must:
1. Insert the battery
2. Connect the Water Timer Electronic to the tap
3. Set the watering program
6.1 Inserting the Battery (Fig. A)
1. Remove the control unit
1
from the housing of the Water Timer by
pressing the release button
5
(see Fig. B/C).
2. Insert the battery (only use a 9 V alkaline battery) in the battery com-
partment (Fig. A).
Note: When inserting the battery pay attention to the +/– markings.
3. Reattach the control unit to the housing.
6.2 Connecting the Water Timer to the Tap (Fig. C)
The Water Timer is fitted with a sleeve nut for taps with a 33.3 mm (G1)
thread.
34
To Next Page
Loading...
Need help?
General
