During the suction cycle, the pump tries to pump for
a max. length of 6 minutes.
6. Storage
To put into storage:
1
q
lf there is a risk of frost, the Electronic Pressure Pump must be
emptied and stored where it will not become frozen.
Store out of the reach of children.
1. Change the switch
q
to O.
2. Unplug the mains connection for the pump.
3. Open the delivery side consumer.
4. Remove the connected hoses on the pressure and suction
sides.
5. Unscrew drain bolt
1
.
6. Tilt the pump to the suction and pressure side until water is
no longer discharged from either side.
7. Store the pump in a frost-free, dry place.
Disposal:
(in accordance with
RL 2012/19/EU)
The unit must not be disposed of with normal household waste
but must be disposed of in accordance with local environmental
regulations.
7. Maintenance
Danger! Electric shock!
Risk of injury due to electric shock!
v Pull out mains plug before undertaking any
maintenance.
Clean built-in filter:
w
e
q
9
ß
A
1. Change the switch
q
to O.
2. Disconnect mains plug.
3. If necessary, close all the
shut-off devices on the intake
side.
4. Unscrew the lid
9
of the filter
chamber with the spanner
ß
A
provided.
5. Draw out filter unit
w e
vertically upwards.
6. Hold cup
w
firmly, turn
filter
e
anti-clockwise 1 and
draw out 2 (bayonet fitting).
7. Hold cup
w
under running water and clean the filter
e
e. g. with a soft brush.
8. Refit filter again in reverse order.
9. Switch Electronic Pressure Pump on again (see 5. Operation).
1
2
w
e
19
To Next Page
Loading...
