4. Operation
DANGER!
Risk of injury if the Turbotrimmer does not switch off when
you release the start button.
v Never bypass the safety devices or switches (e.g. by tying
the safety lock to the handle).
Risk of injury!
v Remove the battery prior to each adjustment of the
working position, to the shaft length, additional handle
or plant guard!
Setting the working position:
Working position 1:
Standard trimming
Working position 2:
Trimming beneath
obstacles
Working position 3:
Vertical trimming
of overhanging lawn
edges
u
Working position 1:
For standard trimming.
Working position 2:
1. Press the foot pedal
u
and lower the shaft downwards into the
desired working position.
2. Release the foot pedal
u
and allow the shaft to engage.
CAUTION! Avoid contact between the ground and the trimmer
head in working position 1 + 2.
z
u
ö
Working position 3 (only for art. 9825):
The upright must be in the uppermost position in working
position 3.
1. Turn the plant guard
ö
by 90° to its parking position until it
locks into place.
2. Press the foot pedal
u
and move the upright into the
uppermost position.
3. Press the button
z
and rotate the trimmer head from 0° to 90°
until it engages.
4. With the impeller, move the trimmer along the lawn edge.
CAUTION! The trimmer may only be used provided that the
trimmer head is engaged at an angle of 0° or 90°.
19
EN
To Next Page
Loading...
Need help?
General