EasyManua.ls Logo

Gardena FlexControl 1883 - 6. MAINTENANCE; Cleaning the Filter; 7. TROUBLESHOOTING; Troubleshooting Display and Manual Issues

Gardena FlexControl 1883
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Disposing of flat batteries:
v Please return flat batteries to a GARDENA
dealer or dispose of them properly at your
nearest recycling centre.
Only dispose of batteries when they are flat.
6. MAINTENANCE
Clean filter [ Fig. I3 / M1 ]:
The filter
r
should be checked regularly and
cleaned when necessary.
1. Unscrew sleeve nut
t
of the Water Computer by
hand from the tap thread (do not use pliers).
2. If necessary unscrew the adaptor
e
.
3. Remove filter
r
from sleeve nut
t
and clean.
4. Fit the Water Computer again (see 3. PUTTING
YOUR WATER COMPUTER INTO OPERATION
“Connecting Water Computer”).
Problem Possible Cause Remedy
No display appears Battery inserted incorrectly. v
Check polarity markings match (+/–).
Flat battery. v
Insert new (alkaline) battery.
Temperature on the display is higher
than 60 °C.
v
Display appears after temperature
has dropped.
Manual watering is not possible
using the rotary knob set to On
Battery flat (
is continuously
displayed).
v
Insert new (alkaline) battery.
Tap turned off. v
Turn tap on.
Controller is not connected. v
Mount controller on housing.
7. TROUBLESHOOTING
EN
25

Related product manuals