An adapter cable may be required to connect
older sensors, which can be purchased from
GARDENA Service, GARDENA Adapter
cable Art. No. 1189-00.600.45.
Fit anti-theft device (optional) [ Fig. I5 ]:
To secure your Water Computer against theft,
you can obtain the GARDENA Anti-theft device
Art. No. 1815-00.791.00 from GARDENA
Service.
1. Tightly screw the clamp
o
complete with the
screw
p
into the circular groove on the rear of
the water computer.
2. Use clamp
o
e.g. for fixing a chain.
It is no longer possible to remove the screw after it
has been screwed in.
4. PROGRAMMING
Tip:
V Program the Water Computer with the tap
turned off.
In this way you can avoid getting wet.
Enter watering program:
To set the programme, the controller can be
removed and mobile programming can be carried
out (see 4. PUTTING YOUR WATER COMPUTER
INTO OPERATION “Insert battery”).
Set time and day
[ Fig. P1 ]:
1. Turn rotary knob to
.
The time in hours flashes.
2. Select the time in hours (example: 10 hours) with
the + button and confirm with the OK button.
The time in minutes flashes.
3. Select the time in minutes (example: 20 minutes)
with the + button and confirm with the OK but-
ton.
The day of the week flashes.
4. Select the day of the week (example: friday) with
the + button and confirm with the OK button.
A bar is displayed beneath the selected day of
the week.
Set watering start time
[ Fig. P2 ]:
5. Turn the rotary knob to
.
The start time hours flash.
22
To Next Page
Loading...
