14
GB
Fault Possible cause Remedy
The Turbotrimmer Filament cassette empty. v Replace the filament cassette
no longer cuts. (see 6. Maintenance
“Replacing the filament
cassette”
).
Cutting filament too short or the v Pull the filament out of the
automatic filament extension cassette manually.
does not work.
Cutting filament inside the v Release filament that has
cassette or fused. disappeared into the
cassette or fused together.
A
In the event of other faults please contact GARDENA Service.
Repairs should only be carried out by GARDENA service centres or dealers
authorised by GARDENA.
8. Technical Data
Turbotrimmer SmallCut 300 (Art. 8845)
Motor power consumption 300 W
Mains voltage /
mains frequency 230 V / 50-60 Hz
Filament thickness 1.5 mm
Cutting width 230 mm
Filament supply 10 m
Filament feed Fully automatic
Weight 1.8 kg
Rpm of filament cassette 11,100 rpm
Work area related emission
characteristic value L
pA
1)
85 dB (A)
Noise level L
WA
2)
measured 94 dB (A) / guaranteed 96 dB (A)
Hand / arm vibration a
vhw
1)
< 2.5 m/s
2
Measuring method according to 1) EN 786 2) directive 2000/14/EC
9. Service / Warranty
GARDENA guarantees this product for 2 years (from date of
purchase). This guarantee covers all serious defects of the unit
that can be proved to be material or manufacturing faults. Under
warranty we will either replace the unit or repair it free of charge
if the following conditions apply:
• The unit must have been handled properly and in keeping with
the requirements of the operating instructions.
• Neither the purchaser or a non-authorised third party have
attempted to repair the unit.
To Next Page
Loading...
