Gardena WT 1030 - Connecting to Water Tap

7
GB
Even if the battery is almost empty, the Water Timer ensures
that an open valve is always closed since less energy is re-
quired to close the valve than to open it.
The Water Timer is fitted with a sleeve nut
4
for taps with a
33.3 mm (G1” ) thread. The adapter supplied
5
allows the Water
Timer to be connected to taps with a 26.5 mm (G¾” ) thread.
Connecting the Water Timer to taps with a 33.3 mm (G1” )
thread:
1. Screw the sleeve nut
4
of the Water Timer onto the thread
of the tap by hand (do not use pliers).
2. Screw the threaded tap connector
6
onto the Water Timer.
Connecting the Water Timer to taps with a 26,5 mm (G ¾” )
thread:
1. Screw the adapter
5
onto the tap by hand (do not use pliers).
2. Screw the sleeve nut
4
of the Water Timer onto the thread
of the adapter
5
by hand (do not use pliers).
3. Screw the threaded tap connector
6
onto the Water Timer.
Connecting your Water Timer :
6
5
4