15
AFTER SALES SUPPORT
1300 922 271
service.australia@
isc-gmbh.info
GLCS 85 E
09/2014
91568
5Before starting the equipment
Before you connect the equipment to the mains sup-
ply make sure that the data on the rating plate are
identical to the mains data.
Always pull out the power plug before making ad-
justments to the equipment.
Assembly (Fig. 3-6)
• Place the chain clamping mechanism in the chuck
(Fig. 3) and screw from underneath using the star
screw (Fig. 4).
• Before starting the chain sharpener, fasten it se-
curely to a suitable surface (e.g. a workbench) at a
suitable place (protected against dust, dry, well-lit)
using M8 fixing screws and washers (Fig. 5).
• Make sure when doing so that the mounting plate
of the chain sharpener is pushed onto the surface
as far as it will go (Fig. 6).
GLCS_85_E_AUS_SPK7.indb 15 05.06.14 13:56
To Next Page
Loading...