6
AFTER SALES SUPPORT
1300 922 271
service.australia@
isc-gmbh.info
GLCS 85 E
09/201491568
10. Don‘t abuse cord
Never carry tool by cord or yank it to disconnect
it from receptacle. Keep cord from heat, oil and
sharp edges.
11. Secure work
Use clamps or a vise to hold work. It‘s safer than
using your hand and it frees both hands to operate
tool.
12. Don‘t overreach
Keep proper footing and balance at all times.
13. Maintain tools with care
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating
and changing accessories. Inspect tool cords peri-
odically and, if damaged, have repaired by autho-
rised service facility. Inspect extension cords perio-
dically and replace if damaged. Keep handles dry,
clean and free from oil and grease.
14. Disconnect tools
When not in use, before servicing, and when chan-
ging accessories such as blades, bits and cutters.
15. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and
adjusting wrenches are removed from tool before
turning it on.
16. Avoid unintentional starting
Don‘t carry plugged-in tool with finger on switch.
Be sure switch is off when plugging in.
17. Outdoor use extension cords
When tool is used outdoors, use only extension
cords intended for use outdoors and so marked.
GLCS_85_E_AUS_SPK7.indb 6 05.06.14 13:56
To Next Page
Loading...