8
AFTER SALES SUPPORT
1300 922 271
service.australia@
isc-gmbh.info
GLCS 85 E
09/201491568
Special safety instructions
• Check that the speed shown on the grinding tool is
the same as, or faster than, the rated speed of the
grinder.
• Check that the dimensions of the grinding tool
match those of the grinder.
• Grinding disks must always be used and stored
with care in accordance with the instructions of
the manufacturer.
• Always check the grinding disk before use. Never
use any disks with pieces broken off, which are
cracked or are in any other way damaged.
• Check that grinding tools are attached in ac-
cordance with the instructions of the manufactu-
rer.
• Always use backing layers if they are supplied with
the grinding tool and their use is specified.
• Check that the grinding tool is properly attached
and fastened before use and allow to run without
load in a safe position for 30 seconds. Stop imme-
diately if it should vibrate heavily or if any other
fault should become apparent. Examine the machi-
ne to find the cause of the fault.
• Never use the electric tool without the guard if a
guard is included in delivery.
• Do not use separate reducer sleeves or adapters to
make grinding disks with large holes fit properly.
• For grinding tools with threaded inserts, check that
the thread is long enough for the length of the
spindle.
• Ensure that the tool is securely fastened.
GLCS_85_E_AUS_SPK7.indb 8 05.06.14 13:56
To Next Page
Loading...