To Next PageTo Next Page
Need help?Do you have a question about the Gardner Denver ELECTRA-SCREW EBE GH-30 HP and is the answer not in the manual?
General| Model | EBE GH-30 HP |
|---|---|
| Category | Compressor |
| Horsepower | 30 HP |
| Type | ELECTRA-SCREW |
| Manufacturer | Gardner Denver |
Gardner Denver's factory remanufactured air end exchange program.
Precautions for operating in cold and extreme cold weather conditions.
Steps to follow before operating a new compressor unit.
Includes oil, air filter, piping, electrical, grounding, and rotation checks.
Procedures for starting the unit when cold or hot.
Procedure for safely stopping the compressor unit.
Details on protective devices like overload heaters and temperature sensors.
Explanation of operating modes like Constant Run, Auto Lead, and Auto Lag.
Meanings of LEDs for high temperature, motor overload, separator, and air filter.
Procedure for programming load and unload pressure setpoints.
Troubleshooting compressor startup and intermittent operation problems.
Resolving problems with loading, unloading, cycling, delivery, and pressure.
Troubleshooting high discharge temperature and excessive oil consumption.
Causes and remedies for oil carry-over in the system.
Diagnosing "CHANGE SEPARATOR" light issues during startup and operation.
Troubleshooting motor overload shutdowns and air filter light issues.
General terms, limitations, and periods applicable to the product warranty.
