13-8-619 Page 4
WARNING
Failure to observe these notices could result in damage to equipment.
• Stop the unit if any repairs or adjustments on or around the compressor are
required
• Disconnect the compressor unit from its power source, lockout and tagout
before working on the unit – this machine is automatically controlled and
may start at any time.
• An Excess Flow Valve should be on all compressed air supply hoses
exceeding 1/2 inch inside diameter. (OSHA Regulation, Section 1926.302, or
local regulations)
• Do not exceed the rated maximum pressure values shown on the nameplate.
• Do not operate unit if safety devices are not operating properly. Check
periodically. Never bypass safety devices.
To Next Page
Loading...
