MOTOR CARE
The motor on your convection oven is maintenance free since
it is constructed with self-lubricating sealed ball bearings.
It is designed to provide durable service when treated with
ordinary care. We have a few suggestions to follow on the
care of your motor. When the motor is operating, it cools
itself internally by air entering at the rear of the motor case,
provided proper clearance has been allowed.
Since the blower wheel is in the oven cavity it is at the same
temperature as the oven. If the motor is stopped while the
oven is hot, the heat from the blower wheel is conducted
down the shaft and into the armature of the motor. This
action could shorten the life of the motor.
We recommend, at the end of the bake or roasting period,
when the oven will be idle for any period of time, or before
shutting down completely, that the doors be left open
slightly.
On the 200 series controllers, push the rocker switch to COOL
position. Once cool set the rocker switch to OFF.
NOTE: Optimal cool-down will be achieved with the door
open slightly.
Part Number 260BGS rev B 4/1516
To Next Page
Loading...
Need help?
General
