BC™ 35 WIRELESS BACKUP
CAMERA
Installation Instructions
Introduction
WARNING
See the Important Safety and Product Information guide in the product box for
product warnings and other important information.
Garmin
®
strongly recommends having an experienced installer with the proper
knowledge of electrical systems install the device. Incorrectly wiring the power
cable can result in damage to the vehicle or the battery and can cause bodily
injury.
When connecting the power cable, do not remove the in-line fuse holder. To
prevent the possibility of injury or product damage caused by fire or overheating,
the appropriate fuse must be in place as indicated in the product specifications.
In addition, connecting the power cable without the appropriate fuse in place will
void the product warranty.
CAUTION
Always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite side of the surface.
These installation instructions do not apply to a specific vehicle type, and are
meant as a guide when installing this product on your vehicle. For questions
specific to your vehicle, you should contact the vehicle manufacturer.
Device Overview
Item Description
À
Transmitter
Á
Camera
Â
Camera mounting bracket
Tools Needed
• Drill and 10.008 mm, or size X (0.397 in.) drill bit
Printed in Taiwan
December 2017
190-02351-90_01
To Next Page
Need help?
General
Weight and Dimensions
