ALARMS FOR THE UPPER AND LOWER LIMITS OF THE OUTDOOR TEMPERATURE AND FROST
INDICATION
Alarm for the upper and lower temperature limits
The weather station allows setting an alarm when a certain temperature between -20 °C and 60 °C is
reached. If more wireless sensors are used, the alarm can be set for each one separately.
Setting the temperature limit:
1) When more than one wireless sensor is used, select the desired channel using button
2) Press and hold button until the arrow and icon flashes
3) Press button or to set the required upper temperature limit
4) Press button to confirm the setting. Icon will flash
5) Press button or to set the required lower temperature limit
6) Press button to confirm the setting
Push button once to activate the alarm. Under the temperature reading, icon appears. As soon as
the set value is measured, a warning tone sounds and the icon flashes. Push any button to stop the alarm
signal. If the reading is above the set upper limit, the icon flashes, if it is below the set lower limit, the
icon flashes. The alarm will be activated until the temperature reading is outside the set limits, or until
the button is pushed.
To deactivate the function, press button , icon disappears.
Frost indication
The frost indication function and the set point alarm are closely linked, when the high and low temperature
alarm is active, the frost indication function is automatically activated.
As soon as the outdoor temperature is between -1°C and +3°C, the icon is displayed.
Note: Even if the icon is not displayed, remember that there is a risk of icing at temperatures
around zero and below.
SETTING THE WAKE-UP TIME
1) Press button , the display will show the wake-up time
2) Press and hold button for a few seconds until the wake-up hour flashes
3) Press button or to set the required wake-up hour
4) Press the button, the set wake-up minute flashes on the display
5) Press button or to set the required wake-up minute
6) Press button to confirm the setting
Activating and deactivating the alarm clock
To activate or deactivate the alarm clock slide the ON/OFF switch to the ON position (activated) or OFF
(deactivated). The alarm is activated if the icon is displayed.
To deactivate the activate wake-up alarm, push any button except .
To activate the SNOOZE function, push the button while the alarm is active, icons or will
flash and the alarm will be postponed for 5 minutes, and then reactivated. This process may be repeated.
If no button is pressed, the alarm with deactivate automatically after 2 minutes. The wake-up alarm will be
repeated after 24 hours at the set time.
To Next Page
Loading...