6) Setting of temperature units
- press the SET button to move to the setting of units of the
indoor/outdoor temperature, press the WIND/+ or PRESSURE/-
button to select units °C (Celsius) or °F (Fahrenheit)
- in the basic display mode, press the TEMP. button to display the
measured values of Wind Chill, temperature index and dew point,
hold the button for 5 seconds to start searching for a new wireless sensor
Note: The main unit measures the indoor temperature, humidity and barometric pressure every 60
seconds. If the temperature is below or above the minimum possible measurable value, the display
shows --.-.
7) Setting of wind speed units
- press the SET button to move to the setting of wind speed units, press the
WIND/+ or PRESSURE/- button to select: km/h, mph, knots, m/s or bft
- in the basic display mode, press the WIND/+. button to display the
measured values of wind speed, wind gusts and wind direction
8) Setting of the precipitation total units
- press the SET button to move to the setting of the precipitation total
units, press the WIND/+ or PRESSURE/- button to select: in or mm
- in the basic display mode, press the RAIN button to display measured
precipitation values, hourly, day, week, month or precipitation total
- hold the RAIN button for 2 seconds to erase the currently displayed
precipitation total
Note:
The wireless integrated sensor transmits the measured values of wind speed and direction and
precipitation total every 16 seconds.
9) Moon phase
- press the SET button to set the southern or northern hemisphere,
STH – southern, NTH - northern
Setting of the alarm clock and alarm for high and low limits
Alarms are used for notification of reaching the set values. When the set values are reached, an
alarm is activated.
Displaying the set alarm values
1) Press the ALARM button to display the set upper alarm limit value
To Next Page
Loading...
