GARNI 940 - Advanced Settings and Data Monitoring; Time, Pressure, and Unit Settings

9
Setting mode
Hold the SET button for 2 seconds to enter the setting mode. The settings appear in the following
order:
1) Beep at button press
- press the WIND/+ or PRESSURE/- button to turn ON or OFF the
beep at button press
2) MAX/MIN daily values
- press the SET button to move to the setting of MAX/MIN daily
values, press the WIND/+ or PRESSURE/- button to turn ON or OFF
the automatic deletion of the daily measured values at midnight of
each day
3) Setting of time and date:
- press the SET button to move to the setting of time and date, press
the WIND/+ or PRESSURE/- button to select 12 or 24 hour time
format
- press the SET button, press the WIND/+ or PRESSURE/- button to
set hour
- press the SET button, press the WIND/+ or PRESSURE/- button to set minute
- press the SET button, press the WIND/+ or PRESSURE/- button to select the date format DD-
MM (day-month) or MM-DD (month-day)
- press the SET button, press the WIND/+ or PRESSURE/- button to set year
- press the SET button, press the WIND/+ or PRESSURE/- button to set month
- press the SET button, press the WIND/+ or PRESSURE/- button to set day
Note:
WiFi firmware V1.4.4 or later supports global time synchronization. When the main unit is
connected to the Internet, the time and date are automatically synchronized and the appropriate
time zone and DST (daylight saving time) are set.
The seconds will be reset when setting minute. If the main unit is connected to a Wi-Fi network, the
time and date will be updated automatically.
4) Setting of barometric pressure
- press the SET button to move to the setting of barometric pressure,
press the WIND/+ or PRESSURE/- button to select units of absolute
barometric pressure (hpa, mmhg or inhg), press the SET button to
confirm
- press the WIND/+ or PRESSURE/- button to set the value of the
relative barometric pressure
- the column to the left of the pressure value shows the difference between the daily average
pressure and the 30-day average (hPa).
Note: In the basic display mode, press the PRESSURE/- button to display the measured values for
the last 12, 24, 48 and 72 hours. Hold the button for 2 seconds to display the values of the absolute
and relative barometric pressure.
5) Solar radiation level
- press the SET button to move to the setting of units of the solar
radiation, press the WIND/+ or PRESSURE/- button to select the
units (lux, fc or w/m2)